Tag Archives: Juniper

Raspberry Pi – Installing Tacacs+ (Part 1)

For those pursuing the Cisco Certification path, getting experience with Tacacs+ is a little easier with a Rapsberry Pi and not having to spend several thousands of dollars for a copy of Cisco’s ACS Tacacs solution. In the video accompanying … Continue reading

Posted in Blog Entries, Cisco, Juniper, Raspberry Pi | Tagged , , | Leave a comment

A Followup Review on SEL-2924 Bluetooth to Serial adapter

After my initial review, writeup and video about the SEL-2924, I read all of the documentation available from SEL’s website (http://www.selinc.com) and found a few things that warranted me doing another video. I made reference in the first video to … Continue reading

Posted in Blog Entries, Cisco, Juniper, Product Reviews, Video Podcast | Tagged , , , | Leave a comment

Juniper – Configuration – First Steps (Part 6) Banner Creation

After setting up a login password for the root account and probably another account and password, your legal department will probably want you to put a banner on your device so that anyone attempting access will be appropriate warned that … Continue reading

Posted in Blog Entries, Juniper | Tagged , | Leave a comment

VirtualBox – An Introduction to the world of Virtual Machines

As I began working with the Juniper SRX100, I remembered that I would need a syslog server, a radius server and probably a tacacs+ server at some point during the learning process. In the past, I would have built another … Continue reading

Posted in Blog Entries, CCNP, Certification, Juniper, Product Reviews | Tagged , , , | Leave a comment

Schweitzer SEL-2924 Bluetooth to Serial adapter

I recently came into possession of a device that should be considered as being a part of everyone’s console kit regardless of if they work on Cisco, Juniper, etc. The biggest problem I run into is when I have to … Continue reading

Posted in Blog Entries, CCNP, Juniper, Product Reviews, Technology | Tagged , , | Leave a comment

Juniper Configuration – First Steps (Part 5) Root P/W, hostname

The first things you need to do when configuring a Juniper device is to set a password for the root account. How I found this command was mentioned in an earlier post by using the help apropos root-authentication. The other … Continue reading

Posted in Blog Entries, Juniper | Tagged , , | Leave a comment

Juniper Configuration – First Steps (Part 4) Rescue configuration

In a previous post, I used the following command request system configuration rescue save to set the current active configuration as the rescue configuration. Since I have had to use this command to clear the Alarm light that I encountered, … Continue reading

Posted in Blog Entries, Certification, Juniper | Tagged , , | Leave a comment

Juniper Configuration – First Steps (Part 2) Alarm light on

After restarting the SRX100 after my last post, I noticed the alarm light turned on after a few minutes. I found the command, run show chassis alarms and entered it on the SRX100. The response came back – No alarms … Continue reading

Posted in Blog Entries, Juniper | Tagged , , | Leave a comment

Juniper Configuration – First Steps (Part 1)

In putting up the post yesterday, I didnt go into the detail I should have. What I initially thought was a password reset with a slight variation ended up being a factory reset, which is where I really wanted to … Continue reading

Posted in Blog Entries, Juniper | Tagged , , | Leave a comment

Juniper Certification quest (Part 2)

My SRX100H purchased on eBay is finally in my hands. Tried to pick it up on Friday from UPS but they couldn’t find it in the terminal although they could tell me on what trailer it had arrived on. Went … Continue reading

Posted in Blog Entries, Certification, Juniper | Tagged , , | Leave a comment